LollyWood
08-05-2008, 10:42 PM
Have a designer Q. In designer, under the surface /domes selection.
I need a 30-45 degree wedge from the bottom-top of the pattern. The closest thing offered in designer is a double bottom dome. workable, but the slight hump near the top could be problematic.(hence the title of dome) Need a flat face along the whole face of the wedge angle.
Is there another method to create a flat angle wedge? Or is the double down my only option. (In Vegas we always double down on 11 ;)) Any advice?
Thanks in advance
I need a 30-45 degree wedge from the bottom-top of the pattern. The closest thing offered in designer is a double bottom dome. workable, but the slight hump near the top could be problematic.(hence the title of dome) Need a flat face along the whole face of the wedge angle.
Is there another method to create a flat angle wedge? Or is the double down my only option. (In Vegas we always double down on 11 ;)) Any advice?
Thanks in advance