Rocky
08-02-2008, 01:06 PM
I just noticed that there is a discrepancy between CW Manual and CW Designer regarding minimum board size.
Manual: "The minimum acceptable size of a workpiece that can
be inserted into the CarveWright is 1.5 inches wide x 0.5 inches thick x 7
inches long. It will be necessary to mount the workpiece onto a jig if any
single dimension is smaller than the stated minimums."
Designer: 6 inches long, 1.75" wide, .25" thick.
Which is right?
Manual: "The minimum acceptable size of a workpiece that can
be inserted into the CarveWright is 1.5 inches wide x 0.5 inches thick x 7
inches long. It will be necessary to mount the workpiece onto a jig if any
single dimension is smaller than the stated minimums."
Designer: 6 inches long, 1.75" wide, .25" thick.
Which is right?