SandBuoy
08-01-2008, 08:40 PM
I started cutting out the Project of the Month birdcage. Instructions say it cuts the parts out in several passes. Since I already had the wood for the 4 door parts I started on it tonight. Picking up 1 x 12 tomorrow for the rest.
I got the the cut outs and it took it in one pass on the first peice. Putting a real strain on the machine so I opened the door after the first one to eat supper. I will stand there while it cuts the other 3 out just in case.
Could this be taking one pass becuase I have 1.130 loaded on my card? If I use 1.126 loaded on my other computer and upload it to disk will it then go back to taking several passes?
I got the the cut outs and it took it in one pass on the first peice. Putting a real strain on the machine so I opened the door after the first one to eat supper. I will stand there while it cuts the other 3 out just in case.
Could this be taking one pass becuase I have 1.130 loaded on my card? If I use 1.126 loaded on my other computer and upload it to disk will it then go back to taking several passes?