binthere
07-29-2008, 02:24 PM
I am sure this has probably been covered at some point before but........
I guess I don't understand how an image is "rounded" at the edges to blend back into the wood. I doubt if I have asked this correctly. For lack of a better example say........a ball image that tapers back toward the wood with the high point in the center. I have seen multiple images on this site where it's been done. Do I need additional software? thanx for any ehlp. http://www.carvewright.com/forum/images/smilies/confused.gif
:confused:
I guess I don't understand how an image is "rounded" at the edges to blend back into the wood. I doubt if I have asked this correctly. For lack of a better example say........a ball image that tapers back toward the wood with the high point in the center. I have seen multiple images on this site where it's been done. Do I need additional software? thanx for any ehlp. http://www.carvewright.com/forum/images/smilies/confused.gif
:confused: