fwharris
07-25-2008, 10:15 PM
Digitalwoodshop
Senior Member Join Date: Jan 2007
Location: NE PA USA
Posts: 1,836
Temp FIX.... for 1.130... could be...
--------------------------------------------------------------------------------
What would happen if you stacked 2 manual paths on top of each other with each with the 1/8 inch bit and selected 1/3 of the thickness (.25) on the first pass and 2/3 (.5) for the second pass and for the 3rd use Cut Path?... That would give 3 passes and Tabs...
I think it will work.... I am cutting my 2nd to last plaque for a Dedication tomorrow and doing other work so I can's try it now.... But Sunday I will give it a try...
2 manual paths then a cut path.... I cut a 3 Projects that Chris created today and they use a V 60 to decorate the edge then a Cut Path, it's the same thing.... And they came out GREAT...
Take a BOW....
And pass another cold one....
AL
Al,
Great concept!
How would over lapping manual cut paths at different depts with different assigned bits.
Bit selection at machine - use the same bit.
Chris,
Would this work around the issue of order of cuts?
Senior Member Join Date: Jan 2007
Location: NE PA USA
Posts: 1,836
Temp FIX.... for 1.130... could be...
--------------------------------------------------------------------------------
What would happen if you stacked 2 manual paths on top of each other with each with the 1/8 inch bit and selected 1/3 of the thickness (.25) on the first pass and 2/3 (.5) for the second pass and for the 3rd use Cut Path?... That would give 3 passes and Tabs...
I think it will work.... I am cutting my 2nd to last plaque for a Dedication tomorrow and doing other work so I can's try it now.... But Sunday I will give it a try...
2 manual paths then a cut path.... I cut a 3 Projects that Chris created today and they use a V 60 to decorate the edge then a Cut Path, it's the same thing.... And they came out GREAT...
Take a BOW....
And pass another cold one....
AL
Al,
Great concept!
How would over lapping manual cut paths at different depts with different assigned bits.
Bit selection at machine - use the same bit.
Chris,
Would this work around the issue of order of cuts?