cut path not working right

[myshop1044]

I'm in the proccess of cutting out an oval with cutpath and I notice it is not making three or four passes, it went straight to the total depth on the first pass and it seem to be putting a strain on the machine.
was there any changes made on tha last relase to cutpath.

Myshop1044

[TerryT]

Yep, it cuts all the way through in one pass now. There are a few other posts about this issue on the forum, you may want to take a look.

[Amonaug]

I'm in the proccess of cutting out an oval with cutpath and I notice it is not making three or four passes, it went straight to the total depth on the first pass and it seem to be putting a strain on the machine.
was there any changes made on tha last relase to cutpath.

Myshop1044


Yes, 1.13 doesn't use incremental passes to perform most of it's functions now. It take 1 plunge at a slower speed, most times for me this produces burned wood.

[myshop1044]

I think they need to go back to the old way, it makes me worry a little too much.

[Digitalwoodshop]

I think they need to go back to the old way, it makes me worry a little too much.

I think they need to give us choices.... Incrument and how much.... and the whole thing....

AL

[myshop1044]

Incrument and how much.... and the whole thing....
that sounds like a election slogan,
We need choices in America and in C W.
you all have a good one
later

Perry

[Digitalwoodshop]

No New Taxes.....

Snicker....

AL

[fwharris]

No New Taxes.....

Snicker....

AL

NO TAXES AT ALL!!

[myshop1044]

I have one better C W gets a 1-800 #