stubrown
07-20-2008, 09:23 AM
Talk about wierd. Every once in a while my machine has a mind of its own.
Ihave had it start carving in wrong place on multiple passes. Example, Did a carve, changed bit to 90 for centerline, then 1/8 for a cutout.
Some times the centerline is not in the desired location, sometimes it is. Then while trying the cutout, it went off the outline in designer.
Last project stayed with carve bit, paqrt came out great, text below had first half missing.
Sent profects to CW who said they ran them with no problems with design or carving. This was followed up by a request for pictures. Did it and now waiting.
Do not mind it much except I have been down more than up, and ruining oak and walnut is costly.
Any ideas?????? HELP
Ihave had it start carving in wrong place on multiple passes. Example, Did a carve, changed bit to 90 for centerline, then 1/8 for a cutout.
Some times the centerline is not in the desired location, sometimes it is. Then while trying the cutout, it went off the outline in designer.
Last project stayed with carve bit, paqrt came out great, text below had first half missing.
Sent profects to CW who said they ran them with no problems with design or carving. This was followed up by a request for pictures. Did it and now waiting.
Do not mind it much except I have been down more than up, and ruining oak and walnut is costly.
Any ideas?????? HELP