Machine Running Real Slow After 1.13 upgrade

[zman]

Doing a carve today I noticed the truck moving real slow up and down, side to side. The Fonts in my carving had alot of burn marks on them. I recently installed the 1.13 software but shortly after that I uninstalled as to a thread I read about the software carving too deep using centerline. Today is the first day of using my machine since uninstalling it. I did call carvewright and I was still carving at the time and we spoke about the firmware might still be at the 1.1.3. I got on the machine and did a version read of my card and it was still 1.13. So I proceeded in taking the firmware back to 1.125. I am now running the same carve as I did earlier and it is carving the way it should. Fast and very little burn. Just FYI to maybe save someone else a headache..

Zman