View Full Version : winchester logo
supershingler
07-16-2008, 08:39 AM
does anyone have or know where i could get the winchester logo
i did a search in the pattern store but no luck
thanks
Kendall
Durtdawber
07-16-2008, 10:13 AM
Try this one. Hope it works for you.
supershingler
07-16-2008, 11:49 AM
thank you it looks good but when i put it on in designer the horse and rider doesnt have the detail can you help me get this more defined
thanks
kendall
Durtdawber
07-16-2008, 12:48 PM
I tried to stay as close to the logo as I could with that one. Try this new one. I filled in the horse and rider to give it more definition.
supershingler
07-16-2008, 01:43 PM
i am stuck at my real job and cant look at it till later
the first was looked good but part of the horse and rider wasnt there
thanks for your help
kendall
ps i may not get back to you till thursday night i have to go out of town
supershingler
07-17-2008, 08:02 PM
thanks Durt
the logo look great
im going to carve a test tomorrow night
again thanks for you help
kendall
supershingler
07-19-2008, 07:36 PM
durt
i carve the winchester logo today
it turned out ok but i had a twist in the board that i didnt see
going to try it on a better board tomorrow
kendall
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.