jerrbitt
07-14-2008, 06:22 PM
Notice on the attached project below the letters T, Y and X, there are slightly scalloped areas next to the oval.
Unfortunatly I did not notice those until after I carved the project. They are only about a 16th deep so I might get by running this through my planer and shaving that off.
But I would like to know what caused it. Any ideas?
Thank you.
Unfortunatly I did not notice those until after I carved the project. They are only about a 16th deep so I might get by running this through my planer and shaving that off.
But I would like to know what caused it. Any ideas?
Thank you.