Traction belts

[Chuck Jarocki]

When using machine belts gradually move over to left side of machine and roll under. Need to find out how to correct belts from moving.

[Digitalwoodshop]

You can remove the belt, cut 1 inch off it and FLIP it and reinstall. Or replace it.

It's the nature of the beast... Belts stretch slightly and cause the creep. Bigger on the Working end.

AL

[Ken Massingale]

You can remove the belt, cut 1 inch off it and FLIP it and reinstall. Or replace it.

It's the nature of the beast... Belts stretch slightly and cause the creep. Bigger on the Working end.

AL
There's no way to adjust the tracking, Al??

[Reset]

Most of the time head pressure is the cause of traction belts curling under....

http://www.carvewright.com/forum/showthread.php?t=7921&highlight=reset

Tommy :)