bdehoyos
07-09-2008, 01:37 PM
Cut path not cutting all the way…
I was running a project and at the end it requested the 1/8 bit to do the cut out …
Having placed the bit the machine started the cut in mid air
It went all the way around and then a little closer to the board a second pass.
It was not until the third pass that the bit made contact with the board.
The process went on and when done there was about ¼ “ left to cut.
I finish the project with my jigsaw and sanding.
I was using ¾ MDF ( I use it because is a cheap way to try carves before actual production)
1.26 v
any ideas ?
I was running a project and at the end it requested the 1/8 bit to do the cut out …
Having placed the bit the machine started the cut in mid air
It went all the way around and then a little closer to the board a second pass.
It was not until the third pass that the bit made contact with the board.
The process went on and when done there was about ¼ “ left to cut.
I finish the project with my jigsaw and sanding.
I was using ¾ MDF ( I use it because is a cheap way to try carves before actual production)
1.26 v
any ideas ?