Northwoods Woodcrafter
06-22-2008, 07:38 AM
Hi folks...
I hope everyone is well. I found some time to play again and something peculiar came up in my Designer software. When I go to Board Settings - Pattern Bit, there are only four selections possible (three ballnose and the 1/8 straight). For the project I'm working on, I'd like to use the 1/16 bit but it's not an option.
What am I missing?
BTW... I searched but not much luck. "Bit" is too short to search on... :-(
Thanks!
Pete
I hope everyone is well. I found some time to play again and something peculiar came up in my Designer software. When I go to Board Settings - Pattern Bit, there are only four selections possible (three ballnose and the 1/8 straight). For the project I'm working on, I'd like to use the 1/16 bit but it's not an option.
What am I missing?
BTW... I searched but not much luck. "Bit" is too short to search on... :-(
Thanks!
Pete