Bob K
06-12-2008, 10:53 AM
Two questions really:
- Since the sensor detects the thickness of the board, what is the purpose of the Thickness setting in Board Settings/
and
- If I want to carve the same thing (i.e. an address) on both sides of the same board, will the sensor get tricked when it is measuring the board when the 1st carved side is down?
Thanks
- Since the sensor detects the thickness of the board, what is the purpose of the Thickness setting in Board Settings/
and
- If I want to carve the same thing (i.e. an address) on both sides of the same board, will the sensor get tricked when it is measuring the board when the 1st carved side is down?
Thanks