View Full Version : Plaques
castingman
06-09-2008, 07:23 AM
Some new plaques with casting inserts. Two down 8 to go.
Michael
Kenm810
06-09-2008, 07:56 AM
Michael,
Beautiful job on the Plaques
and Your castings look Great.
Well done on the choice of Text
Thanks for Sharing
DocWheeler
06-09-2008, 09:43 AM
Michael,
That is a nice combination of crafts, I like your work.
I'm a bit envious of your ability to cast metal. I never did get the forge that I once wanted for my shop let alone a furnace.
Do you case a stud in the backs of the castings to secure them to the wood?
SandBuoy
06-09-2008, 11:21 AM
Nice work Michael. Those inserts you casted and colored sure make the project look great.
castingman
06-09-2008, 11:36 AM
Thanks,
Doc, Don't be to envious, it's 120 deg. in the shop right now!!!
You guys inspire me to do something differant with the little cc. I have a lot of ideas in the works and will be hard at it after the 1st of nov.
Doc, I used epoxy to hold the casting in and managed to cut the hole just right.
Thanks alot, Michael
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.