Board Height Sensor

[gcox06]

I have a Craftsman CompuCarve. The board height sensor is 1/2". The CarveWright has a board height sensor of 1/4". How do I adjust the height sensor of my machine to be 1/4"? Any help will be appreciated.

Thanks

[Kenm810]

Hi gcox06,

First off Welcome to the CW Forum,

Both of these Quotes are form the most resent CW Manual
.25" - 1/4" appears for to be an option.

Owner’s Manual
MODEL CW.01.01

LHR Technologies, Inc. CarveWright™ System (Rev 1.25) 01/09/08

Small Work piece - The minimum acceptable size of a work piece that can
be inserted into the CarveWright is 1.5 inches wide x 0.5 inches thick x 7
inches long. It will be necessary to mount the work piece onto a jig if any
single dimension is smaller than the stated minimums.

SMALL WORKPIECES MUST USE JIG. Any work piece smaller than
1.5 inches wide x 0.5 inches thick x 7 inches long will require jigging