Maintenance/Lubrication

[forqnc]

I know there are a lot of post regarding lubrication and cleaning etc, but they are all scattered around.
I was hoping you could all post here what would you do if you where to take your machine out of production and do a complete overhaul and maintenance.

What would you lube/clean and with what?
Anything special you would check/grease?

One thing I especially need to check is the Head pressure clutch.

[mtylerfl]

I know there are a lot of post regarding lubrication and cleaning etc, but they are all scattered around.
I was hoping you could all post here what would you do if you where to take your machine out of production and do a complete overhaul and maintenance.

What would you lube/clean and with what?
Anything special you would check/grease?

One thing I especially need to check is the Head pressure clutch.

The topic of lubrication/cleaning was covered very nicely by Jeff Birt in the January ' 08 issue of the Tips & Tricks Newsletter

You can download any issue at either of the following links:
http://www.carvebuddy.com/learning_center.html

or

http://www.carvewright.com/cms/tips-and-tricks

[forqnc]

Thanks for the link Michael, I had seen the January issue, but I didn't pay attention to the piece at the end. :rolleyes:

Thanks

[mtylerfl]

Thanks for the link Michael, I had seen the January issue, but I didn't pay attention to the piece at the end. :rolleyes:

Thanks

You are welcome. Hope that helps you! Jeff did a terrific job.