ditchdoc
04-24-2008, 03:45 PM
Just started a project after a cold winter layoff. Put a board in and at the end of the "measuring board" sequence, I get a message that just says "check for board problem"
The board is square and straight. I have blown/vacuumed the machine. Tried several times to re-start the project and get the same message each time. Anyone got any ideas? This is one I've never seen before.
The board is square and straight. I have blown/vacuumed the machine. Tried several times to re-start the project and get the same message each time. Anyone got any ideas? This is one I've never seen before.