Digitalwoodshop
04-17-2008, 07:22 PM
At the end of a 3 hour carve I had a Y Error but it finished and asked for the next bit but it was offset to the right about 2 inches. It faulted after I changed the bit, then I saw the offset cut.
I checked the encoder for skipping and belt tension. I would say belt tension was a little loose. I think the real problem was the 1/16 inch bit... I think after about 700 hours.... I think it needs sharpening or replacement.... This oak proved to be a little tuff for the old girl... I restarted and it zeroed OK so I am thinking replace the bit and tighten the belt.
I think I can salvage the logo and cut it out.
AL
I checked the encoder for skipping and belt tension. I would say belt tension was a little loose. I think the real problem was the 1/16 inch bit... I think after about 700 hours.... I think it needs sharpening or replacement.... This oak proved to be a little tuff for the old girl... I restarted and it zeroed OK so I am thinking replace the bit and tighten the belt.
I think I can salvage the logo and cut it out.
AL