removing and replacing head

[optionman]

can anyone who has actually done this let me know if i'm asking for trouble by attempting this (or should i send the machine back and let them do it). the company is sending another flexshaft assembly since mine became detached from the motor. they e-mailed me the instructions on how to remove the head and then replace it after connecting the new flexshaft. i'm not the most mechanically inclined. Just how difficult is it?

thanks

[Digitalwoodshop]

Wrong Head Deleted:

[optionman]

are we talking about the same job? i'm not messing with the z-truck at all, i am removing the entire head (held by 2 screws in the back near dust muffler, and 1 on each side when looking down) in order to access the motor in back where the flexshaft sheathing is supposed to be permanently attached. your description is nothing like the email LHR sent me

[AskBud]

Here is what I think you are looking for.
Askbud

[optionman]

thanks bud, that's it. now, have you actually done it?

[AskBud]

thanks bud, that's it. now, have you actually done it?
No, I have not. My machine is in for repair at present.
AskBud

[fwharris]

thanks bud, that's it. now, have you actually done it?

Optionman,

I have done it and it is easy to do. Follow all instructions..

Also see your other post "flexshaft part 2"

[optionman]

thanks for quick reply. i shall not fear what lays ahead.

getting .25in corian next week, hope the new flexshaft gets here soon