power fluctuation problem

[mdoyle7272]

i keep getting a power fluctuation problem on my machine it starts to carve and then stops says power fluctuation press enter to proceed it starts then stops. It is on the same circuit it has always been on with no problems at all, until now my machine has 84 hours on it. the flexshaft seems to still have lube ot it but i went ahead and lube it up again. Any help!!!!!!!!!

thanks,
Mark

[Digitalwoodshop]

Most likely a bad power supply. Call LHR 800-573-1226

AL

[thomasj]

mdoyle7272

I had the same problem with my C/C right outa-the-box.

Called LHR and they walked me through some test and determined if was a bad P/S.

They gave me the option of sending the defective P/S bad for replacement or paying a $40.00 'core' charge and they would ship a new P/S out right away. I chose to do that - rec;d the new P/S and all is well.. Core charge will be refunded when I return the bad P/S.

Give them a call...