PDA

View Full Version : A New Fix for an Old Problem



Ivanq
03-23-2008, 11:01 AM
Friday I called CW to get a replacement sensor that had gone bad. While I had a tech on the phone I told him of a problem I've always had with the CW.

When I first bought the machine and was running version 1.20 of the software I would get the CCM error about 30 minutes into each carve. Would do the normal thing and tell the machine to continue. As most users know when you did this the speed of the machine would increase dramatically. This was a very common error for a lot of users with not a real fix.

Then I loaded version 1.126. Now 30 minutes or so into a carve the machine would just speed up on it's own - no CCM message at all.

Told this to the tech who said the machine should not do this so they are sending me a new X Termination Board. I've never heard of that board before and haven't a clue what it does but I do hope that it fixes the problem.

This was the first time I've had to call CW for hardware support and found them to be very helpful. Nice to know.

Cliff in Roswell