Ivanq
03-20-2008, 03:06 PM
I'm getting an error 400, edge detect failure. This is on any type of wood I load - pine, oak, poplar.
I checked sensors and got the following:
y=works
z=works
brd tracking=works
y position=0 with no change if I move the head
firmware=1.126
use=54 hours
If I understand this correct I should get scrolling numbers on the y position if I move the truck across the board. It looks like a failure of the sensor on the bottom of the truck.
Any ideas on what else I should check/fix?
Appreciate any help at all.
Thanks,
Cliff in Roswell
I checked sensors and got the following:
y=works
z=works
brd tracking=works
y position=0 with no change if I move the head
firmware=1.126
use=54 hours
If I understand this correct I should get scrolling numbers on the y position if I move the truck across the board. It looks like a failure of the sensor on the bottom of the truck.
Any ideas on what else I should check/fix?
Appreciate any help at all.
Thanks,
Cliff in Roswell