Trader Howland
03-19-2008, 12:30 PM
I've created a piece of trim 3.5" x 8' long. I want to give it a test run on a 2' x 3.5" piece instead of running the whole length through.
Can I just edit my board settings down to 2' and save the file as test.mpc (or whatever) and run it through--even though the design elements are still running 8' down the length, but are invisible, OR, do I need to delete ALL but 2 feet of the design elements before I can do this?
I guess a simpler question would be: Does the machine read the board settings/measurements or the areas that have design work created in the software--does this make sense?
Thanks up front.
Can I just edit my board settings down to 2' and save the file as test.mpc (or whatever) and run it through--even though the design elements are still running 8' down the length, but are invisible, OR, do I need to delete ALL but 2 feet of the design elements before I can do this?
I guess a simpler question would be: Does the machine read the board settings/measurements or the areas that have design work created in the software--does this make sense?
Thanks up front.