Board problem..

[butch boyer]

No matter what I do cant seem to get by check for board problem.
trys to measure etc seems like it gets hung up trting to go back under upper rollers??

[Dan-Woodman]

Is your board flat?
Is your board long enough that you need a roller stand?
Was your board put under both rollers when you started?
Is your board edges paralell ?

Just a few questions , trying to help
later Daniel

[butch boyer]

5/4 pine 19-3/4 x 7-1/8 looks flat to me.
under both at start.
Parallel looks good to, does not bind.
Goes through process find left end and find right end then when tryes to send board back to right seems to get hung up trying to get back under right upper roller??

[Dan-Woodman]

If you have a digital bathroom scale ,you might check the roller preasure while cranking down the head onto the scale. ( maybe too much preasure ) should be around 85 lbs.
later Daniel

[Jeff_Birt]

Is the board already carved?

Is the Actual Board flat with a smooth surface on both sides?


Are the Feed Trays adjusted correctly?


Has one of the Sander Paper Belts rolled under it self?

[butch boyer]

At work to day will check tonight, thanks for the advice.