hardly
03-15-2008, 07:27 PM
I created a pattern from a JPG drawing and imported it. I put it on the wood, put a circle around it and made the circle a cut path. It worked but the first thing the machine did was call for the cutting bit and homed and then found the board thickness. Once that was done it called for the carving bit, went through the same routine and proceeded to carve. Once the carving was done the machine called for the cutting bit homed and found the board thickness again.
Why does it call for the cutting bit first when it carves first?
Terry
Why does it call for the cutting bit first when it carves first?
Terry