View Full Version : Creating an oblong cutout / hole
Does anyone know how I can cut the entire center out of an oblong hole in Designer, see gif file for example?
DocWheeler
03-15-2008, 11:31 AM
Zeke,
Here you go,
Kenm810
03-15-2008, 11:36 AM
That small --- just kidding http://www.carvewright.com/forum/images/smilies/icon_wink.gif
AskBud
03-15-2008, 11:51 AM
I did not know the exact length of your hole. I did, however, lay out this version as a possible solution.
DrBob
03-15-2008, 12:25 PM
Hi Zeke
Make a line the length that you want "Minus 1/2 the rad on each end" and use the 3/8th staight bit to cut it out depth .78 through the board.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.