View Full Version : Edge Rout On a Cut cut.
kculm
02-27-2008, 06:08 PM
Hi all it is me again, not to be a pain but can this be done on the CW if so how.
I have a pice 34 x 9 x 3/4 in the center I have a 24 x 6 cut out I would like to have the inside of the cutout with some kind of trim. I have a router and I know I can do it after the fact . but I just want to know if the CW can do it.
Thanks
Kenm810
02-27-2008, 06:16 PM
Hi kculm,
Are you talking about something like this.
kculm
02-27-2008, 06:42 PM
Yes, how did you do that.
badger
02-27-2008, 06:54 PM
On the inside cut or I should say pattern, On this particle one I guess he put a rectangle, then you just right click on the line of that the rectangle put down and select bit. Then just pick which edge you would like from that list.
badger
02-27-2008, 06:57 PM
However you are right about probably doing it afterwards. I like to do the routing seperate and save the machine from putting in that carve time on the counter against the warranty.
Kenm810
02-27-2008, 07:07 PM
Sorry it was coffee fill up time.
badger got it http://www.carvewright.com/forum/images/smilies/icon_wink.gif
Ps Batteries in my wireless key board died http://www.carvewright.com/forum/images/smilies/icon_eek.gif
I'm back ---- any way you got now
kculm
02-27-2008, 08:52 PM
Thanks for all the Help. Now that I see how it is done I feel real dumb.
ChrisAlb
02-27-2008, 09:02 PM
Thanks for all the Help. Now that I see how it is done I feel real dumb.
Haven't we all...lol
It's easy once you know how.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.