Edge Rout On a Cut cut.

[kculm]

Hi all it is me again, not to be a pain but can this be done on the CW if so how.

I have a pice 34 x 9 x 3/4 in the center I have a 24 x 6 cut out I would like to have the inside of the cutout with some kind of trim. I have a router and I know I can do it after the fact . but I just want to know if the CW can do it.

Thanks

[Kenm810]

Hi kculm,

Are you talking about something like this.

[kculm]

Yes, how did you do that.

[badger]

On the inside cut or I should say pattern, On this particle one I guess he put a rectangle, then you just right click on the line of that the rectangle put down and select bit. Then just pick which edge you would like from that list.

[badger]

However you are right about probably doing it afterwards. I like to do the routing seperate and save the machine from putting in that carve time on the counter against the warranty.

[Kenm810]

Sorry it was coffee fill up time.

badger got it http://www.carvewright.com/forum/images/smilies/icon_wink.gif



Ps Batteries in my wireless key board died http://www.carvewright.com/forum/images/smilies/icon_eek.gif

I'm back ---- any way you got now

[kculm]

Thanks for all the Help. Now that I see how it is done I feel real dumb.

[ChrisAlb]

Thanks for all the Help. Now that I see how it is done I feel real dumb.

Haven't we all...lol

It's easy once you know how.