up loading question

[837kenny]

Hello Everyone,
Well I just up loaded my frist project and when it was done . I checked the
flash manger it loaded the project Three times . So I called Carvewright and they said they never heard of this before. and told me to format the card.I did and it still loads my projects three times. Any help on this problem would be very appreciated.
Thanks
Kenny

[Router-Jim]

Kenny go to the Designer program and under "File" on the toolbar, go to Flash Manager. That will read your card. Simply delete two of the patterns and see how that works. Did you perhaps save the files while you compared carving time in the different modes?

[837kenny]

Thanks Jim
I did that but it seems like the only time it does not load the project Three times. It will stop loading and a Message comes up Bad Flash
Thank agian
Kenny

[Reset]

Recently had a memory card go bad on me... upload projects were appearing twice on the card. Your card must be a little "badder" than mine was since your getting three copies :)

A new card (replaced free under warranty) solved that problem for me... give LHR a call.

Tommy