X axis problem after replacing gear

[mchristle]

Good morning

I just replaced a X axs sand paper belt drive gear and something is still not right. The X axis seems to move more in one direction than the other. When I had the machine apart I was carefull to clean and then lubed the gears with the proper lithium lubricant. Has anyone seen this, or have any advice?

By the way, where can I find the procedure for removing the sand paper belts? I would like to clean the rollers in case they are not rolling freely.

Happy carving.
Mike

[Kenm810]

Hi Mike,

See if this one helps you out.

[Digitalwoodshop]

The back and forth is the computer sensing a jam and working it back and forth. Sound like you need to remove and clean the gears and look for a missing tooth.

AL

[mchristle]

Thanks, that helped a lot. My vice was just big enough.
Mike