View Full Version : new bit set cleaning
Dragon
02-17-2008, 12:34 PM
Hi all! I bought the full bit set and I'm about to do my 'pre-flight' maintenance on the set screws with loc-tite etc.
The bits were shipped with a protective coating on them. Is there a recommended way to remove the coating, heat perhaps?
Thanks!
Rob
Jeff_Birt
02-17-2008, 12:59 PM
It just peels off.
Kenm810
02-17-2008, 01:16 PM
Rob,
Remember to use a solvent to remove any oil or grease form all the metal parts,
or it may prevent the loc-tite form setting up properly http://www.carvewright.com/forum/images/smilies/icon_confused.gif
Dragon
02-17-2008, 01:40 PM
I put a little heat from a butane lighter on it and the it peeled right off. You could see it just separate from the bit.
Yep on the solvent!!!! i used something i had around called gun scrubber... strips everything... just remember to re-lube.
Once again... the forum cam through!!!
Thanks to all.
Rob
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.