Codes for CW computer

[Chief Boats]

Where will I find a list of the codes to get info from my machine ? eg Hours run.:confused: There must be a manual somewhere.

[Kenm810]

Chief Boats
Carvewright Manual (http://www.carvewright.com/downloads/CarveWright_manual_01_09_08.pdf)
Exploded view parts list (http://www.carveright.com/downloads/parts_list_manual.pdf)

Press "O" on key pad to access Menus containing Hours run

Cut Motor =
Scanning =
Servoing =
Total on Machine =

[Chief Boats]

Thanks Ken, I keep trying to get what i want by pressing options, but have not had any luck. I get some info but not my hours. I thought there may be certain keys to be pressed with arrows. I'll try again tommorrow.:rolleyes:

[Chief Boats]

Thanks again Ken, I printed off your CarveWright Manual. Lot newer than mine, mine is(Rev1.12) 12/20/06. Should be the same I got mine at Sears, CompuCarve System.


Larry

[Kenm810]

Hi Larry,


I believe "O -- 3" is the Option your looking for on page 23


Configuration Menu Options
The configuration menu allows the user to set project and machine
settings as well as access important run-time and serial number data. To
access the Configurations Menu, select the “0” (Options) key at the
CarveWright Main Menu or use the up/down arrows to locate the menu
and press ENTER. Use the up/down arrows to navigate to the following
menu options:


3) Usage Odometer
The Usage Odometer menu option will display the usage of the
machine in hours and minutes.