WoodyMcSander
02-14-2008, 06:54 PM
I was carving my fourth test project since I bought my machine. I went upstairs and when I came back down to see the finished project, the flexible shaft and flex shaft cover were detached from the cutting head sitting flat on the ground.
When I went to re-attach the flex shaft to the cutter assembly it just clicks on and pops back off. It doesn't seem like it wants to lock in place. I push it back down and it pops up. I did have a harder time than I thought it should be when I originally purchased the unit, but eventually (although temporarily) it stayed attached.
Can anyone tell me what I'm doing wrong?
Thanks.
When I went to re-attach the flex shaft to the cutter assembly it just clicks on and pops back off. It doesn't seem like it wants to lock in place. I push it back down and it pops up. I did have a harder time than I thought it should be when I originally purchased the unit, but eventually (although temporarily) it stayed attached.
Can anyone tell me what I'm doing wrong?
Thanks.