Diode perhaps?

[ChrisAlb]

OK, Maybe 13 hours isn't such a good thing...lol

I'm going to venture a guess here and say this little dude I just found on the board is one of the board sensors diodes??

Still have a long way to go on the cut outs but thankfully the board sensors job is done... I hope!

Any ideas??

[Jeff_Birt]

Yep, that's was part of your baord sensor.

[ChrisAlb]

Well I count myself lucky still as it should finish the project. Just goes to show you, no profit realized without expense...

[Digitalwoodshop]

Yep,

I just changed one last night.... My last one... Ordered 2 more this afternoon. Bet your little window is missing too on the sensor. There are 2 emitters and one receiver in the center in that hole.

I bet next project when it starts to measure the board it stops and tells you to clean the board sensor..... There is a $5.00 Core Charge for the sensor so don't chuck it...

AL

[ChrisAlb]

Even though it coughed up a diode (actually both) the project just finished. A total of 14.75 hours.....whew! Even I'm tired.