View Full Version : Removing Coating From Bits
mammirati
01-08-2008, 08:50 PM
I just received the carving bit set from Carvewright and would like to know how to remove the coating from the bits.
pefries
01-08-2008, 08:56 PM
I'm still a newbie. But, I just pealed the coating off the bits. Left the coating on bits I haven't used yet. It's what I've done in the past with my router table.
mammirati
01-08-2008, 08:57 PM
Thanks, I just didn't want to procede without really knowing what I was doing.
Cmdr.Rav
01-08-2008, 09:00 PM
It should be just wax so peeling it off is fine.
Rav
Ron Smith
01-09-2008, 06:12 AM
I just received the carving bit set from Carvewright and would like to know how to remove the coating from the bits.
It is just wax and it comes off when you start your first carving with no adverse effects.
Ron
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.