View Full Version : Stacker Fault # 181
Ron Smith
01-05-2008, 02:36 PM
It's the first time I've had this one come up. Started to run a jewelry box and this came up during the board measuring sequence. Don't know for sure what it's telling me ... but it comes up each time I try to measure. Any ideas?
Thanks,
Ron
Kenm810
01-05-2008, 03:35 PM
Hey Ron.
I found this exceptional stack error 181 (http://www.carvewright.com/forum/showthread.php?t=4712&highlight=error+181) if it helps?? http://www.carvewright.com/forum/images/smilies/icon_confused.gif
Ron Smith
01-05-2008, 03:57 PM
Hey Ron.
I found this...
Thanks Ken ... I looked for these posts and didn't find them. I put in "stacker fault" and it must have overlooked it. I'm pretty sure it's probably a warped or cupped board but don't have time tonight to play. I'll check it tomorrow. Thanks for your help.
Ron
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.