View Full Version : new machine does anthing work?
just4funjojo
01-03-2008, 06:52 PM
anyone help me with a machine that wont start...nothing past CW splash sceen and a flash reader that my computer wont see? pretty much leaves me SOL
DocWheeler
01-03-2008, 07:32 PM
jojo,
If the card is not formated and loaded with the firmware, the CC would probably just look at you like a hungry puppy. And, if your computer can't see the Reader, you can't load the card. So, first things first - make sure that you are on an external powered USB rather than one directly on the machine just to see if power is the problem. Maybe reboot!
I recently received a new card that said "The flash device can not be initilized..." no matter what I did. The next time I started my computer, I tried again and it worked.:confused:
Until you can load the card, I doubt you are going to see a happy carving machine.
just4funjojo
01-03-2008, 07:59 PM
thanks doc,
re boot didnt help. light goes on when I plug flash into computer...but computer does not recognize flash drive.
Bubbabear
01-03-2008, 08:04 PM
If you are trying to see the memory card in my computer it will not. only way to see the memory card content is to try to upload a file from designer
just4funjojo
01-03-2008, 08:13 PM
thanks bubbabear,
message within designer is "flash error" ..... "device could not be initialized. ensure that the flash writer is conected to your computer and card inserted..."
joseph
Kenm810
01-03-2008, 08:59 PM
Hi joseph,
I just return your pm
If all else false, give LHR a call in the am
1-713-473-6572 or 1-800-573-1226
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.