Chandi
01-01-2008, 12:29 PM
Hi all,
I'm having a problem with the scanner probe for the Carvewright machine. The probe won't go down to touch the sled board surface like it did before when I was scanning other items. Keep in mind that it was working before, and I was able to scan other items with the same sled and everything.
1. The sled holding the item to be scanned has 1" rails. This shouldn't be a problem because it worked before.
2. The sled board surface is clean of dust and any sawdust build-up.
3. The probe itself is clean.
4. I've tried re-calibrating the machine.
5. I've tried formatting the card and updating the firmware.
6. The items I'm trying to scan shouldn't be the problem, because the probe doesn't even get that far.
So, any ideas?
I'm having a problem with the scanner probe for the Carvewright machine. The probe won't go down to touch the sled board surface like it did before when I was scanning other items. Keep in mind that it was working before, and I was able to scan other items with the same sled and everything.
1. The sled holding the item to be scanned has 1" rails. This shouldn't be a problem because it worked before.
2. The sled board surface is clean of dust and any sawdust build-up.
3. The probe itself is clean.
4. I've tried re-calibrating the machine.
5. I've tried formatting the card and updating the firmware.
6. The items I'm trying to scan shouldn't be the problem, because the probe doesn't even get that far.
So, any ideas?