hotpop
12-31-2007, 03:40 PM
Maybe not new - V1.125
I drew two circles 3.0" dia. Selected a 1/2 Ball Nose for both.
Circle on the right I selected 0.00 offset. The outside of the cut is now 3.5" dia. as expected.
Circle on the left I selected 0.25 offset. The outside of the cut should be 3.0" dia. but it is about 3.25 dia.
Go figure!
8408
8409
I drew two circles 3.0" dia. Selected a 1/2 Ball Nose for both.
Circle on the right I selected 0.00 offset. The outside of the cut is now 3.5" dia. as expected.
Circle on the left I selected 0.25 offset. The outside of the cut should be 3.0" dia. but it is about 3.25 dia.
Go figure!
8408
8409