carving a chair seat

[rjberns]

How CAN A CHAIR SEAT BE CARVED. DOES SOMEONE HAVE A PATTERN FOR THIS

[mtylerfl]

How CAN A CHAIR SEAT BE CARVED. DOES SOMEONE HAVE A PATTERN FOR THIS

Hello rjberns,

Do you have a photo you could post that represents what type/style of chair seat?

[Keenosan]

I don't know if this is what you're looking for or not. The picture shows the pattern twice, one side flipped horizontally, joined. The reason that I cut it in half is because for a normal-sized chair (17-21 inches) you can't carve it in one pass, you have to join two carvings after you cut them. I hope this helps. If it isn't what you're looking for, you'll have to be a little more specific.

Kelly

[Keenosan]

Bob,

This MPC was done from your measurements. Note that the wood grain in the picture runs the wrong direction since the maximum width you can use on your CW is 14.5"

If this isn't quite right, PM me again.

Kelly