Royal Const
12-17-2007, 12:55 PM
I was wondering if it is possible for the machine to continue carving if there were an Y axis stall point. Rather than just restart the entire carving process and ruining the current wood, is it possible for it to continue carving from the current stall point, instead of press the Stop button and restarting the whole process.
I'm attempting to carve some plexiglass carvings but as you know, it accumulates a lot of excess and the plastic gets wrapped around the bit or goes into the belts can causes a stall.
Any advice or help appreciated.
I'm attempting to carve some plexiglass carvings but as you know, it accumulates a lot of excess and the plastic gets wrapped around the bit or goes into the belts can causes a stall.
Any advice or help appreciated.