jlitz
12-14-2007, 01:27 AM
Moving this thread out of FAQ http://www.carvewright.com/forum/showthread.php?t=1616
I saw this program just today and gave it a try. I went back and joined that forum just so I could leave a "thanks". I'm still awaiting validation over there and since you posted about it here...
Thank You!
I converted one of my Corel graphics and it was wonderful. Now I can create in Corel and carve with the CW. If LHR had done this, I would have been a much happier camper from the beginning...
I wish I had the time to write such software as I used to enjoy such things but life is what it is... Thank goodness some folks like you can squeeze out the time and share it with us!
Rich...
Glad to hear it's been useful.
I do plan to improve the converter. Something is always on the list to do. I'm still not happy with the curve fitting of Bézier paths (with control points) on to Designer 'splines', among other things.
Happy Carving
I saw this program just today and gave it a try. I went back and joined that forum just so I could leave a "thanks". I'm still awaiting validation over there and since you posted about it here...
Thank You!
I converted one of my Corel graphics and it was wonderful. Now I can create in Corel and carve with the CW. If LHR had done this, I would have been a much happier camper from the beginning...
I wish I had the time to write such software as I used to enjoy such things but life is what it is... Thank goodness some folks like you can squeeze out the time and share it with us!
Rich...
Glad to hear it's been useful.
I do plan to improve the converter. Something is always on the list to do. I'm still not happy with the curve fitting of Bézier paths (with control points) on to Designer 'splines', among other things.
Happy Carving