TurkeyBranch
12-03-2007, 07:03 PM
OK, here is the deal.
Machine carves everything out perfect. I get better each day. Although I still have a ton of "Designer Firewood".
When it gets to the edge rout, the bit stays up about 1/2 above the project. Makes all its passes and never touches the board. It see the bit, it touches the bit plate, it homes just fine, or seems to.
Any thoughts, ideas, tricks, or great jokes? :)
Ed
Machine carves everything out perfect. I get better each day. Although I still have a ton of "Designer Firewood".
When it gets to the edge rout, the bit stays up about 1/2 above the project. Makes all its passes and never touches the board. It see the bit, it touches the bit plate, it homes just fine, or seems to.
Any thoughts, ideas, tricks, or great jokes? :)
Ed