View Full Version : edge routing on a curve
potentialbuyer
11-28-2007, 11:15 AM
Is it possible to edge route on a section of a curve? Say I have a circle and only want to route 1/4 of it.
PsalteryDreams
11-28-2007, 12:58 PM
There is an Arc tool which lets you draw arcs by length and radius
forqnc
11-28-2007, 02:04 PM
As PsalteryDreams said, use the arc function. Draw your circle, then draw your arc on top where you want it, and select the bit you want for the arc.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.