file joining

[potentialbuyer]

Is it possible with the CW software to join two objects, if so how?
For example if I design 2 boards say 2x5" each can I join them so the CW will cut the design on what ends up being a 2x10" board. Hope I am making sense.

[pkunk]

Put the 2 objects on a 2 x 10 board ti start with, leaving 7" extra to stay under rollers. Cut apart when done.

[potentialbuyer]

Dont want to part them. Guess I didn't explain very well, what I have is about a 2x14" board about 4" on the end has some intricate curves. The back 10" of the board is square and straight but has a bunch of precisely drilled holes. Easier to layout the back part of the board with out the fancy curved front. So what I was wanting to do is treat it like 2 boards in the software and then join them in the software, solely for the sake of ease of layout.
Hope that makes more sense.