PDA

View Full Version : quick question



jimnjenny
11-26-2007, 07:38 AM
I got a bit error which was my fault, but I wanted the machine to cut my oval out, because I told it to use the wrong bit and I didnt tell the machine to cut thru, can I put the board back in my machine to cut the oval out without screwing up the board? Jenny

rjustice
11-26-2007, 08:07 AM
The machine will repeat pretty well. It would have been excellent if you hadn't taken it out of the machine, but it will still be fairly close.

Ron

oldjoe
11-26-2007, 11:46 AM
It should be fine as long as the measurements the machine comes up with on the board length and width are the same the second time.