PDA

View Full Version : Check Cut Motor



Mike Ray
11-21-2007, 07:41 PM
I get a Check Cut Motor when the job starts. I hit enter and it runs the job. Any ideas?

Kenm810
11-21-2007, 08:38 PM
Hey Mike,

The Check Cut Motor is quite common lately, and folks have posted a ton of ideas about what has been causing it.
Everything form loose or missing rpm sensor magnets to software hic-up or much fine dust left in the muffler bag.
Most people just press enter and continue the carving.
You can also do a forum search key word (Motor or Cut-Motor)

I got the CCM problem only once and tried blowing the motor off with a little compressed air and haven't had it again since.
You might want to call LHR Friday or Saturday the see if their techs have found a solution yet.

CarveWright Service Phone Numbers
For CarveWright and CompuCarve Machines
You can contact CarveWright by phone at
1-713-473-6572 1-713 473-6545 or 1-800-573-1226
email at support@carvewright.com.
New hours are Monday through Saturday 9:00 am To 6:00 pm Central Time.