View Full Version : What's Wrong With This?
DMiller
11-12-2007, 10:28 PM
I'm trying to cut a semi-circle out of the edge of a board. When I load this file on the machine, it just seems to lock up the system. Any ideas of what I'm doing wrong?
JOHNB
11-12-2007, 10:32 PM
d ; you got nothing there but a construction line. highlite it , and add a bit to it.
mtylerfl
11-12-2007, 10:36 PM
Hello DMiller,
You have not applied a "Cutpath" to your arc. What's more, the Cutpath tool won't be available unless you make the arc ends go a little BEYOND the bottom edge of the board (as you have it laid out, the ends stop at the edge).
Either extend the ends of the arc a little beyond the edge, or scoot the existing arc down so that the ends go off the board a tad. Then you'll see the cutpath tool will become available and you can click it to create your cutpath.
EDIT: for JohnB - When you create a cutpath, you do NOT assign a bit to the path - the 1/8" cutting bit is already automatically assigned - don't change it
JOHNB
11-13-2007, 05:55 AM
michael, thanks for the tip.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.