Cutting depth

[Bubbabear]

Ok i am trying to adjust the cutting depth and not real sure how too. Semms everything i try to do it still cuts just about all the way thru. and surely there is a way to adjust to cut different on 3/4 board than on 1/4 board

thanks

[forqnc]

Are you using the cutpath selection tool? If so this will always cut through except for leaving small tabs to hold work piece. If you draw a rectangle and select the 1/8" cut bit then you can set the depth to what ever you want.

[pkunk]

type the depth you want it to carve here.

[Bubbabear]

Thanks guys sure glad i am on vacation for a few days after tuesday. think i need more in learning the program than any thing i am not a designer by birth or trade